Evolution US - RAGE3-DB Double Bevel Sliding Mitre Saw FAQS

Where to Buy

Evolution RAGE3-DB: 255mm Multipurpose Double Bevel Sliding Mitre Saw FAQs

#1 Where can I find the cutting capacities for this machine?
#2 The saw is not cutting at the correct angles.
#3 I can't fit or change a blade to this machine.
#4 How do you unfasten the blade bolt?
#5 The machine has stopped and there is no power.
#6 The blade stopped spinning when I starting cutting.
#7 The head of the machine will not pull down. Or the blade guard will not return.

#	Question	Answer	What to do…
#1	Where can I find the cutting capacities for this machine?	A. Cutting capacities can be found on the specification page in the operator's manual. B. Cutting capacities can be found on the RAGE3-DB webpage.	A. Download Manual
#2	The saw is not cutting at the correct angles.	A. See the operator's manual. B. Check the blade for damage. C. If blade is not parallel in the table cutting slot, the bevel block will require adjustment.	A. Download Manual B. If a replacement is required please contact our customer service team.
#3	I can't fit or change a blade to this machine.	A. See the operator's manual.	A. Download Manual
#4	How do you unfasten the blade bolt?	A. If it is a left-handed thread, unfasten in a clockwise direction.
#5	The machine has stopped and there is no power.	A. Check to see if the laser light works, if yes, first remove the power supply from the mains and check the carbon brushes. Remove the carbon brushes and clean with a dry cloth and then return into the machine. Plug the power supply back into the mains and retry. If the machine still has no power, then it's most likely to be the printed circuit breaker at fault. B. If the laser light is not working, check the fuse in the plug if fitted correctly and check the power cable for continuity.	A. Please contact our customer service team for repair. B. Replace if required.
#6	The blade stopped spinning when I starting cutting.	A. If the motor still runs and sounds normal: B. The gearbox is possibly faulty and may need repairing. C. If the motor still runs but sounds noisy: D. If the full machine shuts down in the middle of cutting, this may be due to a damaged blade, which will cause an overload and the electrics will shut the machine down.	A. Remove the blade and refit, checking that the blade is fitted correctly. B. Please contact our customer service team for repair. C. A new armature and gearbox may be required. Please contact our customer service team for repair. D. Replace the blade, or use a more suitable blade for the job been carried out.
#7	The head of the machine will not pull down. Or the blade guard will not return.	A. Check the guard linkage is still connected at the side of the laser light. See the operator's manual. B. Check that the head max height screw is tightened up correctly and not missing. C. Check that the 3 links are connected by 2x rivets	A. Download Manual B. Refit. May need to remove blade to reset the guard linkage bars. C. Replace if damaged. Please contact our customer service team for repair.

Didn't find the information you were looking for?
Contact our customer service team for one to one help and advice.

SUBSCRIBE TO THE EVOLUTION MAILING LIST.
Receive tailored content from Evolution about new tool releases, competitions, prizes and giveaways, exclusive offers and more.