Evolution US - EVOMAG42 Magnetic Drill FAQS

Where to Buy

Evolution EVOMAG42: 42mm Magnetic Drill FAQs

#1 Where can I find the cutting capacities for this machine?
#2 The drill unit wobbles when cutting.
#3 The drill is not locking up on slide.
#4 The motor is running but no drive to spindle.
#5 There is no power to any part of the machine.
#6 The magnet works but the drill will not run.

#	Question	Answer	What to do…
#1	Where can I find the cutting capacities for this machine?	A. Cutting capacities can be found on the specification page in the operator's manual. B. Cutting capacities can be found on the EVOMAG42 webpage.	A. Download Manual
#2	The drill unit wobbles when cutting.	A. Check the slide adjusting screws are correctly adjusted. B. Check the arbor and support is adjusted and tightened. C. Check the cutter being used is not damaged.	A. See operator's manual for instructions. Download Manual C. Replace cutter if it is damaged.
#3	The drill is not locking up on slide.	A. Check the drill unit locking handle is tightened.	A. See operator's manual for instructions. Download Manual
#4	The motor is running but no drive to spindle.	A. This is most likely a gearbox fault.	A. Please contact our customer service team for repair.
#5	There is no power to any part of the machine.	A. Check the fuse in the power supply and on the machine is fitted correctly. EVO42 V1 type fuse on printed circuit board. B. Check continuity of the cable for any physical damage. C. If the printed circuit board is fitted to the machine this could be damaged from another fault such as a motor burn out, magnet fault or insulation fault.	A. Replace fuse. If it blows again send to qualified person for testing. Please contact our customer service team for repair. B. Replace if it is an open circuit or is damaged. C. Have it repaired by qualified person. Please contact our customer service team for repair.
#6	The magnet works but the drill will not run.	A. Check the carbon brushes. B. Check if the power going into the drill switch and back out is ok. C. If power is going in but not out: D. Check the continuity of the motor connects to the printed circuit board. If no connection:	A. See operator's manual for models. Download Manual B. Drill will require repair. Please contact our customer service team for repair. C. Switch will require replacement. Please contact our customer service team for replacement. D. Drill will require repair. Please contact our customer service team for repair.

Didn't find the information you were looking for?
Contact our customer service team for one to one help and advice.

SUBSCRIBE TO THE EVOLUTION MAILING LIST.
Receive tailored content from Evolution about new tool releases, competitions, prizes and giveaways, exclusive offers and more.